Introduction: Cutting is an important skill in team-sports, but unfortunately is also related to non-contact ACL injuries. The purpose was to examine knee kinetics and kinematics at different cutting angles. Material and methods: 13 males and 16 females performed cuts at different angles (45 , 90 , 135 and 180 ) at maximum speed. 3D kinematics and kinetics were collected. To determine differences across cutting angles (45 , 90 , 135 and 180 ) and sex (female, male), a 4 2 repeated measures ANOVA was conducted followed by post hoc comparisons (Bonferroni) with alpha level set at a 0.05 a priori. Results: At all cutting angles, males showed greater knee flexion angles than females (p < 0.01). Also, where males performed all cutting angles with no differences in the amount of knee flexion 42.53 ± 8.95 , females decreased their knee flexion angle from 40.6 ± 7.2 when cutting at 45 to 36.81 ± 9.10 when cutting at 90 , 135 and 180 (p < 0.01). Knee flexion moment decreased for both sexes when cutting towards sharper angles (p < 0.05). At 90 , 135 and 180 , males showed greater knee valgus moments than females. For both sexes, knee valgus moment increased towards the sharper cut- ting angles and then stabilized compared to the 45 cutting angle (p < 0.01). Both females and males showed smaller vGRF when cutting to sharper angles (p < 0.01). Conclusion: It can be concluded that different cutting angles demand different knee kinematics and kinet- ics. Sharper cutting angles place the knee more at risk. However, females and males handle this differ- ently, which has implications for injury prevention.
|Tijdschrift||Journal of biomechanics|
|Status||Published - 2017|